Problems with Spiral Stairs
It seems very difficult to get the 1/4 round landings attached to the top of spiral stairs. I've also noticed that if I try to use a vanlila catwalk, the rails are pretty far off. The overall diameter of the spiral stairs is not taking up the whole foundation, so when it reaches the top, it's also that far short of aligning with the vanilla catwalks. Any tips for positioning? Any plans to make the overall diameter match the foundation to allow for alignment with vanilla catwalks?
6 Replies
I will check all this
It is true that I did not plan for the spiral staircase to be connected to the vanilla catwalks, but only to foundations
I have no difficulty placing the Stair Landing above the 270° and 90°
On the other hand, only one landing is allowed otherwise the pioneer's head will touch the 2nd landing and will no longer be able to advance
This staircase is designed to fit into a foundation circle as shown in the presentation
But it's a good idea to create a version that would connect to vanilla (I'm adding it to my very long to-do list.)
It is complicated to connect the elements because the (vanilla) basic railing system does not match between the catwalks and the foundations with railing
Both in width and height
So there will be a misalignment anyway.
Or I have to create 3 models for each part, and left right
Plus a version for walkways
Thank you. I understand. I really like your other Architecture+ and partial ramp/stair solutions!