Belt tension all over the place
I recently moved my printer to another table and had it sit there for a couple of weeks. last week i installed the beacon. started it up and started a print, and the quality was not as before. did a belt tension graph and this is what i got. where do i start to re tighten them in the best way?
vcore 3.1 400
ratos 2.1
2gt belts
5 Replies
Tighten them half a turn a retest until your results are worse than the previous test. That means you need to go back a bit
Probably they lost a bit of elasticity since the last time you did the graphs
think i found the problem..
Is it the teeth of the gear being grinded? How did that happen?
the belt is being grinded...