to low z-offset with beacon contact
my z-offset is set to low when beacon is calculating it. is these a way to fix that?
14 Replies
What machine?
vcore 3.1 400
You can use the same calibration steps from Vc4
Moment…
https://docs.ratrig.com/commissioning-guides/v-core-4#z-offset-beacon
ill give it a try
off topic. i dont use prusa slicer, i user super slicer, and had to update it for ratos compability. and i cant connect the printer to send directly from the slicer to the printer. is that someting u know anything about?
Do you have the correct IP set on SS?
yes i have. just copied from the erlier version of ss
Open the machine tab on SS and where you set the IP hit test
its on octoprint, but thats working on the erlier version
Oh… just remove the password
No need
when i hit test it says "Could not connect to OctoPrint: Couldn't connect to server:
Failed to connect to 192.168.8.6 port 80 after 1 ms: Couldn't connect to server
[Error 7]
Note: OctoPrint version at least 1.1.0 is required."
tried that aswell
But that should not be there. Otherwise it will look for a place to use the API/pass and there is none
I can test later with SS and report back
would be really helpful
im on 2.5.5.59.12