E3D PZ Probe
Built a drangon burner for my Voron V0 and used the E3D PZ Probe and EBB36.
During wizard config, used a "Geneic Probe". As it is Voron V0, I had to ad a few lines to the Printer.cfg to get a few things working for bed level and mesh.
Guess V0 was not intended to really have a probe but when I did the mesh, I could easily see I had a "Frame" issue and was able to losten the one Y rail and slighty push up while tightening again.... Problem solved.
My question is simple.... Did I miss something during the setup that I had to manually add lines to the printer.cfg, or should this just have fully worked without any changes?
Can we sometime add PZ probe to the list of probes?
2 Replies
Grats on getting it to work! Adding lines to the printer.cfg is exactly how to customize your printer to use equipment that isn't in the configurator. Haven't heard of a PZ probe and I believe just the most common probes are in there as it is a lot of work to try and maintain each and every option so it is unlikely.
Uses the Revo nozzles.
Make probing on V0 so much more possible and accurate without have to store probe (like clicky) and also is exact same X & Y as your nozzle, so no offset needed
