Rat Rig Community [Unofficial]•4w ago

Poor Adhesion On Edges

I've got a VCore 4 500 and I can't get prints to stick on the edges. Is there a chance that I'm not scanning the edges with the probe? I'm not sure where the grid size location is stored.

7 Replies

MDFPereira•4w ago

What filament are you printing? Enclosed machine? What temps? What machine? What conditions? We need more data. Ratos-debug.zip

heedafOP•4w ago

All types of filament and at any temperature. 90% of the middle of the board prints perfect. It is just the edges. So I'm wondering if I'm not getting leveling on the sides. Ratrig vcore 4 500 IDEX.

blacksmithforlife•4w ago

show us the bed mesh

heedafOP•4w ago

I'll get it uploaded soon. Does the bed mesh have a size setting or is it just based off the plate size?

blacksmithforlife•4w ago

It's based off the klipper config

heedafOP•4w ago

Thank you for the info. Looks like I need to tweek my frame some more after running the mesh calibration. in my v-core-40idex/500.cfg I have the following:

horizontal_move_z: 2
mesh_min: 30,32.5
mesh_max: 470,462.5
probe_count: 40,40

horizontal_move_z: 2
mesh_min: 30,32.5
mesh_max: 470,462.5
probe_count: 40,40

This is what I was thinking might be the problem. Why would the mesh start 30mm from the edges? Seems strange that the edges would need to be adjusted for or is it a limitation of the Beacon?

blacksmithforlife•4w ago

I am not sure, I don't use a beacon currently and didn't setup the offsets. But I imagine they are there for a good reason

Gaming

Programming

Poor Adhesion On Edges

Did you find this page helpful?