Z_TILT HS AFTER UPGRADE RATOS 2.1
Hello?
I switched a new sdcard to RATOS2.1 but impossible to do a z-tilt!
Homing X Y and Z via beacon no problem, position 250.250 but as soon as the z-tilt is launched noise and loss of position !!
Where should I look? Thanks
6 Replies
if execute G1 X100 Y100 F6000 nothing pb
Are you using rat-os?
yes
did you verify your stepper directions?
If my steppers were not good I would not be able to do correct homing?
I put my old engine config back with autotune and it's ok!
But I can't find where ratos configurator has an error!
upload your old printer.cfg and the debug.zip from the configurator