Rat Pack wont start
Install Rat Pack on Octopus V1.1 and configure it as shown in the instructions, but it will not start. Moving the cable to constant 24v (one of the sockets next to the right) will work, but I have no control over the speed. So what I'm doing wrong
[fan_generic filter]
pin: PD15 = 24V
pin: !PD14 = Blue cable
Solution:Jump to solution
Yep. That did the trick.. If I would read more I could have figure it out. Thank you
4 Replies
Did you also activate chamber filter control via the variables?
Yes. Still not working
Ok. Think I see the problem now if the config lines above are exactly the ones used your config, the PD15 pin is incorrectly referred to, it should be set to enable_pin: PD15
Solution
Yep. That did the trick.. If I would read more I could have figure it out. Thank you