Y-Stepper engages for X-Movement
Hello,
I have a strange problem. I have four motors for X/Y (2xX, 2xY).
When I do an X-move (left/right), three motors engage. But when I do a Y-Move (back/forth)only one motor engages.
So my conclusion: The Y1 stepper (which is one of the three moving) is wrongly configured. But I have checked the pin assignment multiple times now and can't find the error.
I have attached the printer.cfg, could someone be so kind and take a look at it? 🙂
15 Replies
Use the STEPPER_BUZZ STEPPER=stepper_x (for example) command to identify each stepper as per your printer.cfg, you either have plugged them in the incorrect steppers on the mainboard or selected the wrong motors in the configurator
That can only be because you have 3 steppers set to X and 1 to Y.
I will take a look at the file later.
Is it AWD?
Is it RatOs 2.x or 2.1?
But the stepper name e.g. stepper_y1 assigns the axis it belongs to, right?
If that is not the case, than the source of the misconfiguration is quickly found 😄
2.1 and it is a c
It’s a c?
ups, cut of half. A cross-gantry
It should…
Ok, then it makes no sense to me. But I'll start buzzing now 😄
Can you show me how you have them connected to the board?
When buzzing stepper_x1 this happend:
x/y worked fine, nothing happend at y1
Oh maaaan
I just saw, that
What kind of stupid thing is that 😦
Solution
Well that fixed it.
Thanks for your help 🙂