Pin 'heater_bed_sensor_pin' is not a valid pin name on mcu 'mcu'
Hello,
I have set up the RatOS for a Minion in the configurator and now I am changing the printer.cfg.
RatOS.cfg is unchanged. I am not sure what causes the above error.
Thanks 🙂
12 Replies
did you have that error before editing the printer.cfg?
Share ratos.cfg, please
No, before I edited it was fine
I just assigned the pins manually and apparently the problem was the aliases section at the top of the printer.cfg
No idea why Klipper does not like this (I even removed the extra komma at the end)
Are you using RatOs 2.x or 2.1?
Because on 2.1 there is no alias section on Printer.cfg
I added that section
2.1 or 2.x?
2.1
2.1 no longer uses alias. It sets pin mumbers on RatOS.cfg
Any unsupported board?
But my RatOS.cfg has the aliases in it?
But does not use it
No, it is a BTT F429
Ah ok
Like I mentioned it was more for comfort so not a big deal
thanks for your help 🙂