Wait for DFU after flashing - Octopus Pro 1.1 H723
I have flashed the firmware, no jumper is on the board.
After the flash, the DFU is not detected.
I am running the board on 24V, motors 48V, the DFU jumper has been removed
11 Replies
I have created this new ticket, but it seems to refer to the same issue that was found here: https://discord.com/channels/582187371529764864/1275256832155193376
i think you are using the wrong board in the configurator
I believe there is another pro 1.1 in there
If the pins in the configurator do not line up with what you have, you have the wrong board selected
What do you mean ? pin layout is matching
Have you done:
Place boot pin
press reset(should show up for DFU)
Remove boot pin
Flash
And if so, have you tried again? 😅
It flash the firmware, but after there is no detection, I have flashed 4 times already
Hm. Interesting. Maybe power cycle everything and try again?
Otherwise Im low on ideas :(
I am rebooting everything now. if it does not work, maybe the firmware uploaded by DFU is corrupted
Solution
OK, it is solved!
So for the Octopus Pro V1.1 H723, the solution is to flash and reboot the whole system
Sweet!!! Glad it's all good