v-core 4 500 idex 8mm bed
mesh is pretty wacky. Have been tuning it for a day so far. Looking to see if I could get some helpful input. Also interested in changing the 40x40 beacon mesh.
15 Replies
I suggest, first and foremost, rotating the PEI sheet.
By 90*
But this looks like a very bent bed or x rail
I'm kinda betting on the X gantry, because its consistent across that part in the left side.
But try first the PEI thing
so i spun the PEI around, and sideways, and the variation is not much. 0.603 vs 0.584 vs 0.593 all looking about the same. also measured the gantry pre install with a drop gauge at work. got it divided into points: 0.00 0.05 0.06 0.07 0.07 0.08 0.09 0.08 0.08 0.07 0.05 0.02 0.01
mm that is on a granite table in our QA department. the bed however you can see light with coming under my Starrett straight edge
in sort of that same pattern as the map
i opted for the 8mm milled bed too.... kinda worried/sad that it's too warped
is that good?
What I wanted to see if the hump would change
And I need an image of that
And if possible an image of the magnetic pei sticker (the black one) too see how it looks.
After that conclude what is happenign we can easily go forward.
today its worse
1st is bed normal, second is bed turned 90
Well this is not an issue @Agony
I suggest litterally pullying the X gantry in the middle UPWARDS
By hand
Put the toolhead on the left side and lift it
With some force
Then redo
Until its flat
getting closer
it's following the beds warp now
Yeah that bed looks bent.
Contact [email protected]
They are on vacation I think but contact hjem