Configuration help

Hello all, I am working on a V0 (will attach current photo below) but want to add another 2 steppers to the Z. I intend to use the TRI-ZERO platform. My question is, would it be possible to add another mcu to my cfg as I have another E3v3? In doing this would it be done in the exact same way as it is in mainline klipper? Or would it be better to just buy an octopus and use that. An extension to that question, to add the extra steppers and tramming would it be easier to configure it as a vcore 3 and just change the sizes? Any help would be greatly appreciated.
No description
2 Replies
blacksmithforlife
If you do the option of adding another MCU, you would start with a vcore config and just override the config on the size and the motor definitions for the other MCU. If you go with an octopus, you would start with a vcore config, and override the size. So either is doable and just depends on what you want to do
Irnc_Isnt_It
Irnc_Isnt_ItOP2d ago
Ok, thanks a mil, I've gone for the path of least resistance and just got a octopus, I will just do it with the vcore config and adjust everything for size and it's belted nature.

Did you find this page helpful?