IDEX Problem 2nd Layer move
Hi, i updated v-core 4 hybrid to idex. since them i cant setup it to correct work.
I done everything in the guide, all looks fine. VAOC Calibration is correct and absolutly fine.
When i print 1st layer test all is fine, so i calibrate my first layer.
When i will calibrate my flow, he will start 1st layer, ok and then it happens.
2nd layer will shift far far away from original. Here some pictures:
Stop printing T0 is not moving to parking position, to see in a picture.
OS ist RatOS, 2.1 RC3.20
first update crashes my system so i updated it the right way, first configurator then klipper.
Whats happen?
Thanks a lot
Solution:Jump to solution
OK i think i fixed it, Problem is Orca Slicer, there ist no IDEX to Choose, so i used my Hybrid Configuration.
In PrusaSlicer all work fine. Why Orca Slicer doesnt can do IDEX?...
11 Replies
here my debug.zip
Hello.
I’m not on my computer so can’t open the zip file.
Are you on performance mode? With cooling for the drivers? You are loosing steps and it can have many causes. The same amount of steps lost on layer 2 are the same that prevents T0 to completely arrive at parking position.
Try setting your accelerations lower and check if it persists.
I would also check belt tension and if all the pulleys are tight against the motor shafts.
Hi,
Are you on performance mode? No.
With cooling for the drivers? Original, out of the Box, and the Electronic Case Cooling Fan.
Acceleration is on Standard Value.
Befor switching to IDEX all work with no Problems.
I tested it with 50% of the default speeds too.
Someone who can help me?
I installed a new Stepper Driver, test belts all work fine. 1st Layer is super, 2nd layer 2nd Object moves away. I dont know what i can do for now.
Thanks a lot.
Problem since IDEX upgrade.
you need to activate the performance mode
Hi, Thanks Helge, but it has begun with the performance mode, for testing i disabled it. And i dont think i lost steps itself, belt overdrive it also not the problem. Layout is on every test the same, 2nd layer is everytime on the same false position.
Hi, i testet last week all i can, i testet stepper motors, belts and pulleyes. i dont know how my problem come from.
1st Object 2nd Layer works, 2nd Object 2nd Layer falls far away.
I dont know.....
@Helge Keck Performance Mode now on!
and the movement is still same, everytime same distance, same angle, i dont beleve this is a hardware problem.
Solution
OK i think i fixed it, Problem is Orca Slicer, there ist no IDEX to Choose, so i used my Hybrid Configuration.
In PrusaSlicer all work fine. Why Orca Slicer doesnt can do IDEX?
Very strange. I now only work without any issues with Orca Slicer and IDEX, first use also the Hybrid Config of Orca and eventually created all the profiles for Orca, look at the slicer topic, I've published this profiles,
Orca is not the recommended slicer at this time. Use prusaslicer until orca gets a little better with their setup 😁
Ok Problem is not solved, when i remove Z-Hub i have same Problem in Prusa Slicer. I Think something with Belts odr Pulleyes. I will remove xy Motors and make a closer look on it. I dont know what i can do else.