Error after installation
Hi!
I have installed latest RatOS and get an error message, and I can't figure it out.
I have followed the guide, did the configure guide.
Had a mismatch , follwed what the text said and still had a mismatch.
I have a BTT Octopus Pro 1.1 with H723.
Regards
Fredrik
10 Replies
The error message makes it sound like the mcu isn't powered on
What can I do to turn it on? What have I missed? I'm new to klipper/RatOS.
All it should need is power.
It is wired up as on the schematics, and it looks like it have power.
One green and three red diods is glowing, one red says status, one says power but I can't see any text besides the third right in front of the power connections, and no text for the green.
//Fredrik
Strange. If you power everything down and bakc up, do you get the same error in klipper?
Yes, every time I have started it up it shows this error. I don't know if I missed something in the guide? I've gone thru it 3 or 4 times, same error. It is so frustrating!
Try reflashing the octopus via ad card?
SD card rather
@blacksmithforlife Have you ever seen that error? "Can not update MCU 'mcu' config as it is shutdown"
Googling around, the only answer I'm seeing is a bad flash on the board, or a bad USB cable
I personally haven't, but changing the usb cable is always a good thing to check
I use the cable that came with the card, I don't have another cable so I gonna buy a better quality and test. I'm away for the holidays, so I test when I get back in january.
Try to reflash it then to.
Good luck!