Wall separation and wobbly straight lines (Good graphs - Low accel) -IDEX 500
I'm doing an accel test and I'm getting wobbly lines on the x axis and wall separation on both axis. I've re done IS couple of times and the problem persist. Print is PLA with 5k accel. Well below recommended accel.
6 Replies
here are my most resent graphs
Initially thought the problem was mechanical because my belts where too loose. Tightened them up more and the same issue
checked the idlers and there is no play
motor pullys also
im completlly lost
looks like a pressure advance issue to me
What if you go down with acc to 1000 or 500 only for a test if its gone then ?