Y layer surface only on X axes movements
Hey on my vcore 4 hybrid I have strange inconsistencies on the Z layer however this only happens on larger objects and only in front and back face. The left and right face is perfect.
I'm pretty sure it is not related to belt tuning. As this does not occur on some objects.
The printer is open and I do see a lot of movement/ vibration on the printer. I have 3 VCORE 3 printers and these are thanks no vibrations at all. However the VCORE 4 does not have corner brackets or maybe it is the different bigger rubber feet that give te illusion the printer is less sturdy.
Trying to get this one solved for weeks now but out of ideas. So hope somoeone can help. Trying to get this printer in production but not like this.
I'm pretty sure it is not related to belt tuning. As this does not occur on some objects.
The printer is open and I do see a lot of movement/ vibration on the printer. I have 3 VCORE 3 printers and these are thanks no vibrations at all. However the VCORE 4 does not have corner brackets or maybe it is the different bigger rubber feet that give te illusion the printer is less sturdy.
Trying to get this one solved for weeks now but out of ideas. So hope somoeone can help. Trying to get this printer in production but not like this.
Solution:Jump to solution
Hey found the issue and did the first clean print .
I tightened alle the screws in the print head. There was a minor wobble in the printhead. So unscruwed the extruder and the pheatus retightened all screws and put things back together. First print is a succes.
Finally....
4 Replies
since it is one the front and back - perhaps the cords attached to the printhead are pulling/pushing it a bit while printing?
Hey woud that be caused by overtight belts? Il check the print head this evening of I can see slack when manipulatieve the print head.
I don't think so
Solution
Hey found the issue and did the first clean print .
I tightened alle the screws in the print head. There was a minor wobble in the printhead. So unscruwed the extruder and the pheatus retightened all screws and put things back together. First print is a succes.
Finally.