Idex 500 has error when swapping toolheads to second color.
First layer printed fine with T0, as soon as it swapped to T1, I got this error 6x:
Error evaluating 'gcode_macro _BEACON_APPLY_RUNTIME_MULTIPLIER:gcode': ZeroDivisionError: float division by zero
Any and all help is greatly appreciated.
9 Replies
@Helge Keck , I marked the endstop convo as solved and moved the new error at swap here.
Added the 3mf I'm printing from
I did notice I had not corrected the offsets I put in before for each extruder so I'm correcting that now and will try to print again
yeah those settings didn't matter
still getting the error at toolhead swaps
only mention I can find is where you / @Helge Keck and @miklschmidt are talking about it here: https://www.answeroverflow.com/m/1281717086204465263
RatOS 2.x + Beacon ignoring configured offset and discarding offset...
I believe I've accurately followed the steps outlined here:
https://github.com/HelgeKeck/RatOS/blob/documentation_v2.1/site/docs/configuration/beacon_contact.md#6-first-print-and-fine-tuning
I've printed a simple single layer print, baby stepped the offset, and then executed
SAVE_Z_OFFSET.
Doing so resulted in the following output on the con...I followed this guide to configure PrusaSlicer: https://github.com/HelgeKeck/RatOS/blob/documentation_v2.1/site/docs/slicers.md
GitHub
RatOS/site/docs/slicers.md at documentation_v2.1 · HelgeKeck/RatOS
The preconfigured Raspberry Pi image that makes it easy to run Klipper + Moonraker + Mainsail on your printer. - HelgeKeck/RatOS
please do not triple post
I won't
i answered already in the idex channel
I'll keep it here
ok
solution was to re-run temp calibration in VAOC.