The first layer worsens during printing
Do you have suggestions to get if fixed?
I’ve followed the commissioning guide and printed a, heat tower.
I’m printing with Amazon PETG.
Solution:
Jump to solution
I’ve repeated the beacon calibration after heating the bed for an hour at 85ºC and now it appears to be solved
3 Replies
By raising the Z-Offset value from 0.098 to 0.298 it recovered, but why did this happen if it had tested the Z-Tilt at the beginning of the print?
Solution
I’ve repeated the beacon calibration after heating the bed for an hour at 85ºC and now it appears to be solved