Need config help on adding a section for a second part fan
hello. this may be a stupid question but couldnt find an answer for it. I have installed a Aux fan in my V0 and couldnt seem to figure out the config to add it to the printer. i tried naming the fans differently to stop klipper freaking out. Is there a proper way of adding a second fan in the same section as my part fan but supplying power from a different port?
(simplified- What text do I add to config to add an AUX part fan with power from a different port than part cooling fan.)
4 Replies
It isn't simple as you need to define multi_pin in the correct place
so if you were going to do it how would you go about it? It doesnt need to be activated by the part fan gcode, as long as i can toggle it on mainsail itd be fine
https://github.com/jscancella/myKlipperFiles/blob/main/vcore3-printer.cfg#L24
But that's a very old configuration
GitHub
myKlipperFiles/vcore3-printer.cfg at main · jscancella/myKlipperFiles
Contribute to jscancella/myKlipperFiles development by creating an account on GitHub.
thanks