Rat Rig Community [Unofficial]•2mo ago

Dual Extruder Set Up Issues

I'm trying to run two orbiter extruders inline with Belay to prevent filament feeding issues on my 500mm VC4. The second extruder pulling off the spool does not move at all and I cannot find what I did wrong (the extruder does work when plugged into the toolhead, so it's not a mechanical failure). I'm using the following config, and after several hours of searching cannot figure out what I did wrong. I've tried using the SYNC_EXTRUDER_MOTION EXTRUDER=my_extra_extruder MOTION_QUEUE=extruder but only ever get the error The value 'my_extra_extruder' is not valid for EXTRUDER Please help, I've spent hours on this and I know it shouldn't be that hard to get working

[belay my_belay]
extruder_type: extruder_stepper
extruder_stepper_name: my_extra_stepper
sensor_pin: ^PF4
multiplier_high: 1.05
multiplier_low: 0.95
debug_level: 1

[tmc2209 extruder_stepper my_extra_stepper]
uart_pin: PG8 #CS Pin on Octopus Max Diagram
stealthchop_threshold: 0
interpolate: False
run_current: 0.707
sense_resistor: 0.11
driver_TBL: 0
driver_TOFF: 4
driver_HEND: 6
driver_HSTRT: 7
driver_SGTHRS: 40

[extruder_stepper my_extra_stepper]
extruder: extruder
#   The extruder this stepper is synchronized to. If this is set to an
#   empty string then the stepper will not be synchronized to an
#   extruder. This parameter must be provided.
step_pin: PA8
dir_pin: PC7
enable_pin: PC9
microsteps: 64
full_steps_per_rotation: 200
rotation_distance: 4.63

[belay my_belay]
extruder_type: extruder_stepper
extruder_stepper_name: my_extra_stepper
sensor_pin: ^PF4
multiplier_high: 1.05
multiplier_low: 0.95
debug_level: 1

[tmc2209 extruder_stepper my_extra_stepper]
uart_pin: PG8 #CS Pin on Octopus Max Diagram
stealthchop_threshold: 0
interpolate: False
run_current: 0.707
sense_resistor: 0.11
driver_TBL: 0
driver_TOFF: 4
driver_HEND: 6
driver_HSTRT: 7
driver_SGTHRS: 40

[extruder_stepper my_extra_stepper]
extruder: extruder
#   The extruder this stepper is synchronized to. If this is set to an
#   empty string then the stepper will not be synchronized to an
#   extruder. This parameter must be provided.
step_pin: PA8
dir_pin: PC7
enable_pin: PC9
microsteps: 64
full_steps_per_rotation: 200
rotation_distance: 4.63

3 Replies

TheTik•2mo ago

I'm off in bed, but am curious about this problem. Does belay have install directions?

Ross13OP•2mo ago

Dead stepper motor driver 🙃 It was a brand new one, so didn't think to swap it out until this morning So the above config is golden

TheTik•2mo ago

Score!

Gaming

Programming

Dual Extruder Set Up Issues

Did you find this page helpful?