Commissioning V-Core 400 IDEX
Should I raise the part of the extrusuion where the L stepper motor is?
If I can’t reach the perfection, what is a good range to consider it OK to proceed to the next step?
4 Replies
AFAIK less than 0.1% of the size of the bed it's good
I have a V core 4 500. I managed to get it under 0.2 so If i were you I'll try to tweak it a bit more
Thanks for your feedback. Rewatching this https://youtu.be/h7ZTq2dDTkM?si=3nVj-fL0wO5PE69W&t=1097 if I want to improve the blue corner I have to lower, not raise the L motor extrusions.
3D Printers & a Whiteboard
YouTube
RatRig V-Core 3: How to Get a Square Frame
This video is for those who struggle getting bed meshed with their RatRig V-Core 3.
Please feel free to jump to the chapter you are interested in.
0:00 Intro
1:05 about the v-core 3 frame and bed leveling
8:26 what to take care of in the building phase
9:17 the right square
10:09 build tips
16:50 adjusting the frame according to your bed mesh
...
A little better 🙂
good job dude!