Z-Offset being ignored
My printer (VC4) seems to be ignoring z-offset adjustments.
I even checked the reported coords and the Z doesn't change (besides tiny adjustments from ABL) when I send e.g.
SET_GCODE_OFFSET Z_ADJUST=-0.01 MOVE=1.
I also checked what happens when I save the offset afterwards and run another print and it looks like it’s ignored as well. This results in my first layer being too low.
The only way I can effectively change the offset is via recalibrating the beacon, but I have no control over that.
I noticed it happening after updating my printer ca. 3 days ago.4 Replies
how are you saving the z-offset?
SAVE_Z_OFFSET before the print ends.Did you check the various posts on #ratos-support that deal with z offset? There have been many posts related to beacon
I didn’t. I kinda assumed it was a bug introduced recently, because until that update everything worked fine for a few months