Need suggestions on how to improve
Hi, I have this mesh on a Vcore-4 500. I think it needs some improvements. Any suggestions on what to do?
8 Replies
Is this before or after you put your mag sheet and plate?
before
and before the heater
looking at my X extrusion I do have the feeling it is a bit bend. Bit down in the middle. When I put a level on the rail and a flashlight behind it I can see light peeping through. Could that cause this?
yep, looks much better. good enough or can even be better?
Well since your X is flat
You can now fix your back of the frame
Since its a f core 4
You can either push the back left corner down, or lift the right corner up
If you wanna fiddle with it.
For a 500 0.2 is good, but of course nothing is stopping you from tapping it VERY LIGHTLY
To fix it jus that bit.
If you want of couse.
Or just use Kapton on that corner and you are okey.
Not going to tough it again!!
Great work!