Do you need to reflash your boards if you move to RatOS
I have a running VzBot triple Z and one to move to RatOS. My boards (Octopus v1.1 and SHT336 Pro(tmc5160) are flashed with lates Katapult and Klipper. All running CANBus. Do I still need to Flash the boards with the configurator, and if not, where are the uuid settings for the boards in RatOS.
Solution:Jump to solution
Thanks for the information. I understand that for some people, CanBus is overwhelming, but so is RatOS. I may end up pulling all the parts needed to run without flashing and keep Canbus
2 Replies
@Raven 3D Tech RatOS doesn’t support canbus.
The boards must be connected via USB.
Connect your boards with USB a flash with configurator.
You can modify RatOS with printer. cfg overrides.
But with canbus it is your decision to make it work.
For canbus there will be not official support.
Solution
Thanks for the information. I understand that for some people, CanBus is overwhelming, but so is RatOS. I may end up pulling all the parts needed to run without flashing and keep Canbus