VCore4 400 CoreXY Graphs
Just finished building my VCore4 400 CoreXY. Wanted to make sure my graphs were decent before I went to add the hybrid kit.
1 Reply
Looks good to me. Very similar results to what I had on a 500 including those bumps on the right. If you haven’t installed them already, I wish I would have tested this thought but I’m curious if unplugging your hybrid stepper motors might get rid of those bumps on the right. Otherwise, just make sure to heat soak your printer then run your hybrid shaper graphs. The belt tension graph becomes obsolete after you install hybrid.
https://discord.com/channels/582187371529764864/1286893948924592188