X axis inverted after upgrading from 1.2 to last release :
Every thing went fine but when testing motion, x axis is inverted. I have tried all config of ! before dirpin in printer.cfg. Is it possible the motor wiring had changed in 2.0? And have only the problem on x motor?
Solution:Jump to solution
so looking carefully the picture, i think i was wrong : x homing = 0 , et y homing is ymax; so the right config is putting ! before each x and y pin; will try this
9 Replies
rule #2, please attach your printer.cfg 🙂
you can't just use
! on a single motor that is corexy. BOTH motors are used to move in X and Y
https://docs.vorondesign.com/build/startup/images/V0-motor-configuration-guide.png
ah yea! I gotta remember that one
ok i will attach the printer.cfg asap
there
i was aware of corexy stuff so i tried all config :pog:
just to be clear i was thinking x=0 at the physical endstop and y = 0 at the other physical endstop (left backward
Solution
so looking carefully the picture, i think i was wrong : x homing = 0 , et y homing is ymax; so the right config is putting ! before each x and y pin; will try this
no, 0,0 is front left. The Y endstop is at Y MAX
yeah thanks to confirm
will try to home and close this thread thanks all
so all homing ok; going to next step i close the thread