[Vcore 4 500] Struggling with this one.
I have my bed as level as I feel I can achieve right now. I am seeing this odd dip on the left side and can't for the life of me adjust it out of the heatmap. Can anyone offer some advice on where I should start?
Solution:Jump to solution
That is so small it isn't worth chasing it. You will never see that little.
9 Replies
if its 0.186 diff you can probably just continue with the build
that range on a 500 is perfect
Well thats very good to know and I'll take that advice.. But I wonder if there is a reason for that dip in the middle of the left side?
you could try adjusting y linear rails but i think its just the bed shape
it could be the y linear rails being more torqued to the extrusion in that place
I have tried resetting the tork along that rail. Even with the t-nuts pretty loose it doesn't change by much. I wonder is the 3030 extrusion is not straight?
Might be
most likely its the bed
no reason to mess with it more though
Solution
That is so small it isn't worth chasing it. You will never see that little.
Just use kapton tape if you're unhappy and really wanna mess with it
Ok and thanks for all the reasurance.