RRC
Rat Rig Community [Unofficial]•2w ago
DJDupid

Has any used the adxl built into the EBB42 for input shaper?

I have the EBB42 with the adxl built in and am wondering how I would go about getting ratos to see it. I uncommet the adxl in printer.cfg but then get an error that is isn't connected.
Solution:
Are you uncommenting the sdxl part within the tool board section?
Jump to solution
5 Replies
TheTik
TheTik•2w ago
I have, not near my computer at the moment though
Solution
TheTik
TheTik•2w ago
Are you uncommenting the sdxl part within the tool board section?
DJDupid
DJDupid•2w ago
my man thank you I missed that one.
TheTik
TheTik•2w ago
Woo!
DJDupid
DJDupid•2w ago
its running the auto calibration now. Thanks! how do you choose the max accel to decel. Is it the X value or Y value?
Want results from more Discord servers?
Add your server
More Posts
VC4 500 hybrid y resonance speed lowI just ran the resonance tests again, and I'm seeing charts that look great for X, but y is showing 4028 Inverted behavior on EBB42. Even with !fan_part_cooling_pinI know this is mentioned multiple times here but i can't seem to solve it. I'm building an VCore 3.Euclid with brush Macro ConfigurationHello friends, I made the Euclid recording with Brush myself and wrote the code. Since I have only bFlashed the wrong board in the configurator, how to remove it?During setup of RatOS V2.1, I ended up flashing my BTT MMB board instead of my EBB 42 toolboard (whiunload macro differenceHi, recently I have upgraded my Minion to ratos 2.0.2 and from that time I face clogs after use unloFan Lüfter Steuern Printer.cfgHallo Freunde ich möchte gerne meine Lüfter in Klipper einbinden und bekomme es leider nicht gebackeVcore 3.1 500mm Mesh HelpAny recommendations on fixing the bed mesh are greatly appreciated thank you !klippy_uds_address issueJust updated everything and now moonraker can't connect to klipper. Has anyone come across this isHelp! How do I make my IP static?Sorry if this has been asked before but my IP changes everytime I turn on my printer.adding beacon mesh points?Running ratOS 202 with beacon revH Is there an easy way to add a bit to my printer cfg that will a