Auto levelling problem
How to fix my auto levelling ?
23 Replies
The Auto levelling doesn’t do its job.
What printer, z-probe and firmware are you using?
Im using probe pinda and mainsail
Are you having a z tilt, or a z offset issue? Your title and question don't line up
I dont really know why the auto levelling doesn’t work
Even i already fix the probe calibration
The z tilt doesn’t really synchronise with each other or the auto levelling doesn’t work i dont know
What happens when you try? Do you get any error messages? What makes you believe it isn't working? Have you posted your printer.cfg?
I dont get any errors but the auto levelling doesn’t do the job because the nozzle hits the other parts of the bed when i try to print stuff
What does the console say when you run z-tilt?
What kind of printer do you have?
I have the vcore3
It doesn’t say something bad only the numbers when i run the z tilt
What are the numbers? How many rounds does it do? Have your printer.cfg?
Only 2 or 1
Best 3
Do i need to do something in the printer.cfg
Link it here
Can i link it tomorrow because the machine is on my workplace
I don't know that I'll be any help, I'm mostly trying to get useful information out of you so smarter people can take a look.
Ok thanks
Here is the printer.cfg
The z-tilt stopped at 2/10
When trying to calibrate
@TheTik
I tested it and it didn’t do so well
This part was so close to the nozzle and scraped the bed
And i dont know how to solve this problem
2/10 is fine. But don't confuse z-tilt with bed mesh. You could still have twist in your gantry or bent linear bearings or just your frame not being square that can cause what you are seeing without bed mesh compensation