Enclosed Vcore 3.1 500, any pointers?
This is the best mesh I've had in the past couple of days since building the printer. Have my frame straightened to the best of my ability without taking it all apart again, tried taking out the bowing by loosening the gantry rail and retightening it according to the well known video. I don't know if I can get it any better given the size, of if I'm safe with this mesh.
8 Replies
Not bad for 500, but is that cold or heatsoaked?
That's superb for a 500... Start printing stuff
this is already heatsoaked yes
friend told me so aswell, wasn't sure about it since it is my first printer with abl 🥲
As they said, start printing. My best heat soaked 500 was .160 but it is usually between .210 and .260. I could do a little better with tiny adjustments but until the V-core is in a permanent place I won't invest the time.
Yeah I'm waiting for a toolhead upgrade since the wireloom is sagging a lot and pulling on the head a bit when fully extended. So for now it'll have to do I think
I had to extend my wireloom for the same reason, longer piano wire actually made it sag less, go figure.
Good that you remind me, I forgot I was gonna do that as a temporary solution😂