VCore 3.1 random klipper error
Hi I'm getting a klipper error message as seen below. The printer is stalled and will not function since this happened and afaik no settings were changed.
4 Replies
That var got changed
https://www.klipper3d.org/Config_Changes.html
Ok so it due to an update then?
I will be on site tomorrow to check it but I asked if the employees could get into the printer cfg and I think the answer was no.
So of this variable changed does that mean the line needs to be removed from the cfg? Why wouldn't the update just do that on its own instead of bricking your printer?
no idea on that one, it's just an error/question I've seen here a lot
max accel to decel was deprecated, should be removed and replaced by "maximum_cruise_ratio: .5" although the .5 you may have to play with.