missing perimeters?
I tried switching from ss to prusa for the organic supports and the result was this mess. It's like it's not printing perimeters despite them being in the gcode and the slicer settings (2). Any ideas where my prusa config has gone wrong? Ss prints fine.
8 Replies
Are they thin?
I don't think so. I don't have the "detect thin walls" turned on fwiw, but the walls are like 6-7mm thick.
Can you send the gcode?
it's half a gigabyte 😐
a clip, perhaps?
slice another part perhaps
similar results
i had printed the above (a shape from the prusa slicer library) to make sure it wasn't the model I was using
also I started over from scratch, sort of, in that I reset to the factory generic pla and HF .2mm profiles, but still using my .6mm nozzle printer profile. Currently printing a temp tower and it looks as one would expect. So it really looks like i've done something terrible to the other profile(s), just not sure what
well, i couldnt see anything in the file
but if you have it working, i guess just proceed slowly