My prints are interrupted.
Hello. My printing has been interrupted for the last few days. The clipper connection is also working. When I reconnect, it says "interrupted" on the track I last sent to print. I examined the log files and there is no information. I couldn't find out what could be causing this.
I also want to say this for extra information. Since the first day I built the printer, there has been a warning in clipper notifications that the voltage has fallen below 4.65 volts. but this has never been a problem before.
Solution:Jump to solution
I was feeding Raspbery via jumper cables via the BTT motherboard. I was getting a voltage drop error on Raspbery from the beginning, but I didn't take it into consideration because it didn't cause any problems at first. Now when I had a problem, when I fed Raspbery with its original adapter, my problems were solved. I also had a filament jamming problem and it was solved when I lowered the retraction setting from 5mm to 1mm.
21 Replies
I think I found the problem, do you think this is the problem? Also, when I say "flash again" it waits but nothing happens and the page comes back..
How are you powering your pi?
I power the pin terminals with motherboard jumpers.
bağlantılarım bu sekilde
My connections are like this
I cut off the power to the motherboard. I replaced the boot0 jumper. My connection is like the sky above. I gave the power back to the motherboard and the raspberry via the power supply. I went to the motherboard flashing section via raspbery (ratos.local/configure) and chose to flash in dfu mode. I pressed the reset button on the motherboard. but it didn't happen. No matter how many times I try, I cannot see the motherboard and cannot flash it via DFU. I don't have an SD card, I can flash it via SD card.
Do any lights come on the octopus, to confirm it has power?
Yes, I have no problems with power. The printer was already working and all the energy is still coming properly.
Hello. While printing, my printer suddenly stops in a random position. When I look back, the file I am trying to print says "interrupted" with a yellow exclamation mark on it. I put the log file here for your convenience. What could be the reason? Can you please help?
I am not familiar with klipper logs, sorry. Glancing at it, I don't see any errors so I'd start looking at external causes, like loss of power
When printing stops, this error appears on the screen. It gets fixed when I do a "firmware reset".
Never seen that error before, but it's talking about an update failing. Do you have any automatic updates enabled?
no
Team FDM
BEWARE: Latest Klipper update breaks symlink to mcu on USB connecte...
Just came across this on discord. May or may not be relevant to you but be aware that the latests Klipper update may break the symlink to the mcu:
I found such a post on the internet. This is what I mentioned here in my post. but when I tried the solution I got this error
Oof. That doesn't look fun. Maybe save your printer.cfg and reinstall klipper
Solution
I was feeding Raspbery via jumper cables via the BTT motherboard. I was getting a voltage drop error on Raspbery from the beginning, but I didn't take it into consideration because it didn't cause any problems at first. Now when I had a problem, when I fed Raspbery with its original adapter, my problems were solved. I also had a filament jamming problem and it was solved when I lowered the retraction setting from 5mm to 1mm.