Overtemp Error after changing 4028 fan
Hello everyone, today I swapped my 4028 for something useful and as it always goes, the next part glitches when trying it out. Has anyone ever experienced something like this before? I've already swapped the drivers.
The 3 Z-drivers have very different temperatures. One around 35 degrees, one at 55, and one over 60. They are cooled by a 140mm Noctua fan on top of the Octopus. X and Y are each around 30. When the print starts, it stops with this message. This only happens in performance mode since i changed the 4028... Does anyone have an idea?
4 Replies
upload your printer.cfg
I don't see anything in your config that would cause an issue(unless that
[include calibrate.cfg] is doing something funky). I would try swapping the driver with another one and see if the issue follows that driver around. If it does, replace the driverThe [include calibrate.cfg] actually does strange things. I removed the entry once, after that it didn't print any circles 😂 I think it would be the best to reset RatOS? Strange that the error only occurred after the exchange of the 4028. I've already swapped drivers too, but it always sticks with the 'stepper_z1' error message.