BTT SFS 2.0
Still having issues with BTT SFS 2.0
This is what I currently have in my printerconfig file as per the instructions. But every print when it starts it goes to the back and parks.... just stays paused. It's like the sensor is backwards.
[filament_switch_sensor switch_sensor]
switch_pin: ^PG12
pause_on_runout: False
runout_gcode:
PAUSE # [pause_resume] is required in printer.cfg
M117 Filament switch runout
insert_gcode:
M117 Filament switch inserted
[filament_motion_sensor encoder_sensor]
switch_pin: ^PG13
detection_length: 2.88 # accuracy of motion sensor 2.88mm
extruder: extruder
pause_on_runout: False
runout_gcode:
PAUSE # [pause_resume] is required in printer.cfg
M117 Filament encoder runout
insert_gcode:
M117 Filament encoder inserted
Solution:Jump to solution
I found this in the vcore mods section and it works great!!! BTT V2 SFS Smart Filament Sensor install on Ratrig : https://wiki.circuitlaunch.com/BTT-V2-SFS-Smart-Filament-Sensor-on-Ratrig-6d153a7734e14531a74e5e2cc28e1c38
I couldn't find much help on Discord or the web on installing the Filament Runout Sensor. Here is my Tutorial on it with a V-core 3.1 500 on the Octopus Pro V1.01 board. Hope this helps someone set this up....
Circuit Launch on Notion
BTT V2 SFS Smart Filament Sensor on Ratrig | Notion
Getting this to work was more than a bit Tricky for me. Hopefully my settings will help. In the Manual (PDF) linked in the references it shows what the best place to plug it in for your MCU. I have the Octopus Pro V1.01
2 Replies
Printer will work if the sensor is disabled in mainsail.
But as soon as printer enables the sensor it pauses.
Solution
I found this in the vcore mods section and it works great!!! BTT V2 SFS Smart Filament Sensor install on Ratrig : https://wiki.circuitlaunch.com/BTT-V2-SFS-Smart-Filament-Sensor-on-Ratrig-6d153a7734e14531a74e5e2cc28e1c38
I couldn't find much help on Discord or the web on installing the Filament Runout Sensor. Here is my Tutorial on it with a V-core 3.1 500 on the Octopus Pro V1.01 board. Hope this helps someone set this up.
Circuit Launch on Notion
BTT V2 SFS Smart Filament Sensor on Ratrig | Notion
Getting this to work was more than a bit Tricky for me. Hopefully my settings will help. In the Manual (PDF) linked in the references it shows what the best place to plug it in for your MCU. I have the Octopus Pro V1.01