V-core 300 first mesh cold and hot
V- core 3.1 300 enclosure 2.0
What can be done to improve it?
3 Replies
Hello,
I’m not an expert but you should take a look at this video : https://www.youtube.com/watch?v=h7ZTq2dDTkM&ab_channel=3DPrinters%26aWhiteboard
You should start by make your back plate corner flat. So in this case I would suggest you to lower B. It also seems that you have a bit of bowing on your X axis.
3D Printers & a Whiteboard
YouTube
RatRig V-Core 3: How to Get a Square Frame
This video is for those who struggle getting bed meshed with their RatRig V-Core 3.
Please feel free to jump to the chapter you are interested in.
0:00 Intro
1:05 about the v-core 3 frame and bed leveling
8:26 what to take care of in the building phase
9:17 the right square
10:09 build tips
16:50 adjusting the frame according to your bed mesh
...
Thanks for the help, I will do that when I have some time, now I'm busy with moving to another house.
@Lusn I honestly don't think you have to adjust it at all. the risk you ate going to make it worse over improving it is very high