mcu replacment
Hi simple question
Patient VCore 3.1 500
MCU need to be replaced
MCU: BTT Octopus 1.1
RatOS stands on RPi 4B
During replacment is it neccesery to go through all instalation from RatOS instalation and firmware instalation,
or
Can MCU be swapped and SD card inserted from old one to new one, and thats be all?
Im not an expert but if i remember corectly that STM Chip on MCU uses SD card as it system files storage,
Thanks in advance
Solution:Jump to solution
no need to reinstall ratos (that is on the raspberry pi). Just run through the configurator again and have it flash the firmware to the octopus replacement and then update your printer.cfg if you are using a different board
1 Reply
Solution
no need to reinstall ratos (that is on the raspberry pi). Just run through the configurator again and have it flash the firmware to the octopus replacement and then update your printer.cfg if you are using a different board