v minion
Hey guys, i just installed ratos on my SKRrat V1.0 and after editing the printer.cfg to have that eact board, i have this issue but i can't really seem to understand how to correct it.
6 Replies
Upload your printer.cfg
Do you have a toolboard? if not, you shouldn't have uncommented line 267
i don't
right i thought that was to configure the probe. but although you are correct, that does't mess with the heater bed right?
no, but the config file is a summation of all the sections. If you are adding things out of order, it can give you unintuitive errors
turns out that was the error all along... Thank you so much for your help!