Heatbreak/Coldend Clog
After a nasty failure that caused some breaking, I now have a rapido with a clogged upper heatbreak and coldend. Filament fills the bigger diameter Section so that I cannot install the ptfe properly. How can I fix this? I already pushed a 1.5mm metal rod carefully through the hotend from the bottom that is long enough to clear the heatbreak, but I have no idea how to get that gunk of platic out of the coldend
3 Replies
I just noticed I can screw the heater and heatbreak from the coldend, I will do that, hopefully it allows me to access the coldend properly
got it out by completely disassembling the hotend.
huh. ok I reassembled everything but can't feed filament. wtf
ok nevermind, I just killed my hotend 🤬️