Heightmap not applied to the print object
Hi, i just boot up my V-minion after a long break and after all updates i tried to print something. I noticed that my printer doesnt want to use the heightmap i generated. I know my bed is not perfectly leveled and i should try better but still, shouldn't the printer use the heightmap to adapt to a bed not leveled? How i should modify the printer.cfg to use the heightmap?
Because the objects printed on the higher side of the bed have the first layer properly squished but the objects on the lower side dont.
4 Replies
0.4mm is very bad, you should fix that first
I know 😄 , i was trying to print something to see what else i should calibrate when i noticed that the first layer is not perfect for all objects on the bed. some have a perfect layer but the objects from the lower side of the bed doesn't. I thought the printer use the heightmap . Or should i use some commands in printer.cfg?
you can put some tape on the leadscrew so you can better see the leadscrew moving during printing to confirm it is applying the height map
however I will say your printer.cfg does not follow best practices. You have changed things all over the place instead of doing it as you are supposed to in the
USER OVERRIDES sectionill try a clean install of RatOS