Beacon not triggering
I just wired up the beacon probe and the red LED turns on when I place a piece of metal underneath it but it still shows z probe as always being triggered. I was using the standard p&f probe before so im guessing I need to change something in the config so that klipper will use the pi port not the octopus probe port for the pin signal. Anyone have experience with this? I have attached my printer.cfg file
6 Replies
Delete this
comment out this
Delete this
Oh, delete this too
And then home xy (G28 X Y) and run BEACON_CALIBRATE
Will try that soon. Thanks for taking a look!