BTT Smart Sensor Pauses after Prime Blob, Doesn't detect during print.
I installed a BTT smart filament sensor V1 (SFS) and when I start a print during the prime blob it goes from "active" to "empty" in mainsail and pauses the print immediately.
Then to be sure, I snipped the filament before it went in and it didn't detect the runout.
I put the macro in the user overides config but I might have missed something somewhere. Appreciate any help. Config included.
3 Replies
I don't have the BTT but when same happened to my Orbiter the cfg setting was wrong, I wrongly inverted something.
Don't think anything is inverted. Maybe the pin slot but it didn't work when I took the ! off
Did you have a sensor at all or was it just the orbiter needing to be reversed?
It showed empty with filament in and when filament was inserted it wanted to unload instead of load (auto response on the Orbiter), Unfortunately I do not remember what exactly I screwed up at the time, not that it would help you since the BTT is different.