ASA overhang problems
I'm trying to print the decoupler mod for the motors, but I can't get this overhang right on my vminion. I tried to print it slower at around 50mm/s, but that did only improve it a bit.
5 Replies
for bridges I'm using 20% of the 4028 fan.
otherwise it's at 0
rising-crimson•2y ago
I’ve heard of someone needing 100% fan with PolyMaker ABS on overhangs at 20mm/s otherwise the overhangs were garbage. Try slowing down more on overhangs and increase fan higher.
ok will try that thanks
Do a few test prints to try speeds between 25mm/s and 0-100% fan for overhangs. Sometimes, a little fan blast on overhangs will give better results overall.
will do that thanks