network issues
Hey guys... my vcore is connected to my home network via Eth cable, but now I want to use wifi instead.
Using klipperscreen, there is a "system" / "network" menu. A few weeks ago, I could see/ choose all available wifi networks... but now, this screen just shows "ETH0 - connected"... even if I unplug the eth cable... something seems to be stuck here...
The "RATOS" hotspot is still active...
Any suggestions how I can go on from here?
5 Replies
other-emeraldOP•2y ago
When I ssh onto the pi and go to sudo raspi-config, it t tells me that there is no wifi adapter...
other-emeraldOP•2y ago
other-emeraldOP•2y ago
nevermind.. I updated the whole system and now it works again..
Next time just use the configurator
https://os.ratrig.com/docs/installation#wifi-or-ethernet
Installing RatOS | RatOS
Raspberry Pi Installation
Yes, use the RatOS hotspot to setup your wifi. Just like it says in the guide ☝️ . You can do this at any point in the printers lifetime.