Probe issue with BIQU Microprobe
So yeah, I'm having serious issues. At first I was getting random drops of the tip. I'd start a print just to find that the tip of the probe didn't retract and was pulling the first layer off the bed. Then at times, it would deploy mid print and the tip was hitting the part. We found that the probe wasn't always retracting, as if there wasn't enough power. The tech figured out that the problem was probably inductance. I took all the cabling out and placed it back in the harness in a careful manner and now that issue is gone. And the probe finally deploys and retracts at command. However, now every time I home I get "Endstop z still triggered after retract".
3 Replies
printer.cfg?
BENQ?
biqu maybe?
Auto correct.
I just made a discovery. My endstop isn't triggering.
I think maybe I have abroken cable.
It is probably the signal or ground cable. White or black I believe in the BIQU Microprobe.
I just don't know where the pins end up connecting on the BigTreeTech board to test continuity.