Toolboard/PT1000 - ADC out of range
Hey! I'm trying to get my EBB36-1.2 to recognize the pt1000 in my RapidoV2 and I keep getting the "MCU 'toolboard' shutdown: ADC out of range" error.
I added the new sensor type, and made sure the jumper was connected on the toolboard. Any ideas where I'm going wrong?
Thanks!
https://github.com/Buster-Grob/Buster-Grob/blob/main/printer.cfg
GitHub
Buster-Grob/printer.cfg at main · Buster-Grob/Buster-Grob
Config files for my GitHub profile. Contribute to Buster-Grob/Buster-Grob development by creating an account on GitHub.
4 Replies
modern-tealOP•2y ago
I did try adding the resistor amount of 2200, but it didn't change anything, so I took it out. Also just not sure if I'm not making the changes correctly
You have to override the pin it is using for the thermistor. Right now it's still using the one on your octopus
Something like
sensor_pin: toolboard:YOURPIN where YOURPIN is the pin name on your ebb36modern-tealOP•2y ago
PA3
I thought I tried that, but I'll give that a go again.
Still not working for it
I updated the config on the GitHub. Am I just adding it wrong?
modern-tealOP•2y ago
Never mind, it's just a broken pt1000
