RRC
Rat Rig Community [Unofficial]•13mo ago
VisualTech48

Beacon constantly triggered

I've managed to install the beacon, with the UHF, and it does work, as when I go close with a metal it glows red on the motherboard of the beacon. However, before I go BEACON_CALIBRATE I have an issue. The Z-Probe of beacon is constantly triggered. Is there an error?
No description
3 Replies
VisualTech48
VisualTech48•13mo ago
I have the Beacon listed so I assume the board is not broken:
No description
miklschmidt
miklschmidt•13mo ago
I don't remember if mine did this, but all bets are off before you've run BEACON_CALIBRATE, so please do that 🙂
VisualTech48
VisualTech48•13mo ago
Seems to be that way yeah just didn't wanted a crashed bet. Bed*
Want results from more Discord servers?
Add your server
More Posts
Bed Hitting Print HeadI am running the V-Core 3.1 with RatOS and using the Super P.I.N.D.A probe. At first my probe was trPrinter not follow bed meshHi guy. My printer doesn’t follow the bed mesh at all. What I have done is just do the print start nAWD enclosed VC 3.1 500 y belt tension issueok so im doing the belt tension right now and my x axis is looking very good, however my y is not. iHigh peak at around 130Hz in belt tension with FMMMHi, I've been searching for a while now and checked almost every part of the printer. I checked evePriming & Printing with .6 nozzleJust switched to the Rapido .6 nozzle (changed extruder setting in config) and priming and printing Hotend Reading OffSo i finally have my v-core 3 setup, however the hotend thermistor is reading 158 C at room temp. ItRandom layer shiftsSo lately I've been bothered with random layer shift in my prints. Not sure why or how it happens. DHelp tuning print settings.Spectrum 275 ASA. 260 nozzle and 60 bed. Getting a lot of pinhole. Layers don't look very uniforme.Option 'control_pin' in section 'bltouch' must be specified after installing inductive probeHey All, I just installed an inductive probe to replace my BLTouch, I went through my printer.cfg,Drucker stürtzt bei zu lange drücken abSetup: RatOs; CB1; SKR 1.4 Stützt ab wenn zu lange gedruckt wird.