Bed Hitting Print Head
I am running the V-Core 3.1 with RatOS and using the Super P.I.N.D.A probe. At first my probe was triggering at all times, but when I rewired it, it began working as expected. Now suddenly it has began to not trigger at all when the bed comes near it and the bed runs straight into the bed.
5 Replies
maybe it's to far away from the bed
rising-crimson•2y ago
It does not trigger at all? like if you put metal pliers directly below - no trigger?
If its the case, i'd re-check the wiring, then try with another board (to see if the board is not the source of the problem) and finally conclude that the probe is just broken (screwed in too tight maybe?)...
rival-blackOP•2y ago
I realize now I was stupid and I didn't have the magnetic layer on the bed and I think that was the reason because it was triggering when I put my screwdriver next to it which is magnetic and I wasn't thinking about that when I made the post.
rising-crimson•2y ago
lolz. I ALMOST did the same. setup the bed, setup probe and almost tried 'lets see if it works ok' while the actual print layer was still in the packaging...
rival-blackOP•2y ago
Yeah now I feel so stupid because I was stressing over it so hard XD