Option 'control_pin' in section 'bltouch' must be specified after installing inductive probe
Hey All,
I just installed an inductive probe to replace my BLTouch, I went through my printer.cfg, uncommented the probe sections and then commented out the BLTouch sections. Saved my config and restarted. Now Im getting this message and cant see anywhere that BLTouch is being used. Anyone got any ideas? I have an EBB42 V1.1 installed on an Octopus board
10 Replies
Can't open zip files on my phone. You are better off uploading just the printer.cfg
Had a look into your CFG file... I don´t see any uncommented BLTouch entry.
I would really reboot the complete device first and look what happens. Added your CFG for further analysis for others.
dependent-tanOP•2y ago
I have restarted many times now, through Save and Restart, Firmware Restart, Host Shutdown and Physical power switch to the MCU. Still getting the BLTouch Control pin message
@miklschmidt may be you can help @scarletvengeance ?
That last line is the problem
So manual removing of this line would fix that... good to know.
@scarletvengeance remove the highlighted lines in your config
yes it's kinda unfortunate that SAVE_CONFIG saves device specific information in a section that isn't supposed to be edited, but.. yeah.
dependent-tanOP•2y ago
Hah! Worked a treat! Amazing! I can get it all configured and dialed in now! Thanks Everyone!
np!