Asking for PrusaSlicer Premade Config
Hi there,
So I got a Vcore3.1 with Volcano hotend, dual 5015s and using Mini Sherpa.
I have problem running at 8K with 100mm/s. There is not enough cooling.
Is there a premade PrusaSlicer Config i can use as reference ?
6 Replies
And the Prime Blob get clogged at the beginning as well.
I run dual 5015 and it is plenty of cooling for PLA. Are you sure they are fully spinning?
Yes. I put two of them in full throttle
Did you measure the voltage at the fan connections at the hotend to verify they are getting the full 24v? Did you use a tachometer or something to verify they are actually spinning at max speed?
Yes. I did all of it. But I also figure that my Volcano hotend need to extrude at high speed.
80mm/s is the minimum
This is my fan test as well. 2 is better than 1